11 – Event Log Configuration
Starting and Stopping Event Logging
11-2 59263-01 A
S
Starting and Stopping Event Logging
Enter the Set Log Stop command in an Admin session to stop recording event
messages in the switch Log as shown in the following example:
SANbox (admin) #> set log stop
Enter the Set Log Start command to start recording event message in the switch
log as shown in the following example:
SANbox (admin) #> set log start
Displaying the Event Log
Enter the Show Log command to display the event log. Each message has the
following format:
[ordinal][time_stamp][severity][message_ID][source][message_text]
Table 11-1 describes the message format components.
Table 11-1. Event Log Message Format
Component Description
[ordinal] A number assigned to each message in sequence since the last time
the alarm history was cleared.
[time_stamp] The time the alarm was issued in the format day month hh:mm:ss.ms
UTC yyyy. This time stamp comes from the switch for events that
originate with the switch, and from the workstation for events that
originate with QuickTools or Enterprise Fabric Suite 2007
[severity] The event severity: A–Alarm, C–Critical, W–Warning, I–Informative
[message_ID] A number that identifies the message using the following format: cat-
egory.message_number
[source] The program module or application that generated the event.
Sources include Zoning, Switch, PortApp, EPort, Management
Server. Alarms do not include the source.
[message_text] The message text
To Next Page
Loading...
Need help?
General
