2 – Command Line Interface Usage
Opening and Closing an Admin Session
59263-01 A 2-3
A
Opening and Closing an Admin Session
The command line interface performs monitoring and configuration tasks.
Commands that perform monitoring tasks are available to all user accounts.
Commands that perform configuration tasks are available only after entering the
Admin Start command to open an Admin session. A user account must have
Admin authority to enter the Admin Start command.
The following is an example of how to open and close an Admin session:
SANbox #> admin start
SANbox (admin) #>
.
.
.
SANbox (admin) #> admin end
NOTE:
A switch supports a combined maximum of 19 logins or sessions, which are
reserved as follows. Additional logins will be refused.
îš„ 4 logins or sessions for internal applications such as management
server and SNMP
îš„ 9 high priority Telnet sessions
îš„ 6 logins or sessions for Enterprise Fabric Suite 2007, QuickTools,
Application Programming Interface (API) , and Telnet.
To Next Page
Loading...
Need help?
General
