Managing the Projector Using Web Image
Monitor
Using Web Image Monitor, you can check the projector status and change settings.
To use this function, specify the following settings:
• Connect the projector to a network using [Network Settings]
• Select [Enable] in [Web Image Monitor] under [Network Application Settings]
To enable this setting after you change it, you must restart Web Image Monitor.
For details, see page 125 "Network Settings Menu" and page 134 "Network Application Settings
Menu".
The following web browsers are recommended for Web Image Monitor:
• Windows:
Internet Explorer 8.0 or higher
Microsoft Edge
• Mac OS
Safari 8.0 or higher
• Display and operation problems can occur if you are using a non-recommended web browser.
• You must enable JavaScript and cookies on your web browser to use Web Image Monitor.
• If you use Internet Explorer, you must enable native XMLHTTP support to use Web Image Monitor.
• You can access Web Image Monitor more quickly by registering the projector's URL as a
bookmark.
• Depending on the setting in [NW Settings on Standby], the projector does not respond even if the
projector is in standby mode. Press the Power button, or change the setting in [NW Settings on
Standby] to [Wired LAN] or [Wired/Wireless LAN] so that the projector can be turned on from
standby mode via a wired LAN or wireless LAN.
Displaying Web Image Monitor
1. Start your web browser.
2. Enter "http://(projector's IP address)/" in your web browser's URL bar.
Top Page of Web Image Monitor appears.
9. Maintenance
166
To Next Page
Loading...
Need help?
General
