• Depending on the computer, the image may not be projected properly if it is displayed on the
computer's LCD display while being projected onto the screen by the projector. If this happens, turn
off the computer's LCD display. For details about switching the display, see the manual provided
with the computer.
Turning Off the Projector
• Unplug the power cord if the projector will not be used for an extended period of time.
• After disconnecting the power cord, wait at least 1 second before connecting the power cord
again. Not doing so may result in a malfunction.
1. Press the [Power] button.
The confirm screen appears.
2. Press the [Power] button.
The projector beeps and enters the standby mode.
3. Disconnect the power cord.
• After turning the lamp off, wait about five minutes for the lamp to cool before turning the lamp on
again. The lamp may not light if it is very hot.
• The projector turns off as soon as the power cord is disconnected (direct power off).
• You can specify the settings for saving energy in standby mode in [Energy Saving Settings]. For
details, see page 116 "Energy Saving Settings Menu".
2. Projecting an Image
38
To Next Page
Loading...
Need help?
General
