• If registration succeeds
The message "Registration has completed." appears. The computer USB adapter flickers every
two seconds. Press the [Enter] button to close the message.
• If registration fails
If there are any obstacles between the projector and computer, the attempt to perform
registration will fail.
Registration should complete in under 2 minutes. If it does not complete after 2 minutes,
remove the USB adapter from the computer, and then insert it again.
11. Press the [Menu] button twice to close the menu screen.
• Do not register computer USB adapters for multiple projectors at the same time. The computer USB
adapter might not be registered correctly.
Enabling the Projector to Recognize the Electronic Pen
Once the projector recognizes the electronic pen, you can directly operate the computer display on the
screen.
1. Turn on the projector.
For details about how to turn on the projector, see page 35 "Turning On the Projector".
2. Connect the computer to the projector using an RGB cable or an HDMI cable.
For details about how to connect the computer to the projector, see page 30 "Connecting to the
RGB out port" and page 30 "Connecting to the HDMI port".
3. Project the computer screen on the projector screen.
For details about how to project the computer screen, see page 36 "Projecting an Image".
6. Using the Interactive Function (RICOH PJ WX4152NI only)
88
To Next Page
Loading...
Need help?
General
