EasyManuals Logo
Home>Sega>Arcade Game Machines>Grid 42

Sega Grid 42 User Manual

Sega Grid 42
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
15
TROUBLESHOOTING
96
TROUBLESHOOTING
15
15-1
TROUBLESHOOTING (WHEN NO ERROR MESSAGE IS SHOWN)
• In order to prevent electric shock and short circuit, be sure to turn power off
beforeperformingwork.
• Be careful so asnot to damage wirings.Damaged wiring can causeelectric
shockorshortcircuit.
• After removing the cause of the functioning of the Circuit Protector, reinstate
theCircuitProtector.Dependingonthecauseofthefunctioning,usingtheCircuit
Protectorasiswithoutremovingthecausecancausegenerationofheatandre
hazard.
• Intheeventthataproblemcannotberesolvedbyemployingtheprocedures
listed inthisManual,be suretorequestservicefromtheofficeshownonthis
Manualorthedealerfromwhomtheproductwasoriginallypurchased.Attempts
toemployproceduresotherthanthosespecifiedinthisManualcancause
electricalshock,shorting,orre.
• In the event of a problem that is not described here, be sure to contact the
ofceshownonthisManualorthedealerfromwhomtheproductwasoriginally
purchased.Carelessattemptsatrepaircanresultinelectricalshock,shorting,or
re.
If a problem occurs, rst check to make sure that the wiring connectors are properly connected.
15 TABLE 01
PROBLEM CAUSE COUNTERMEASURES
When the main SW is
turned ON, the machine
is not activated.
The power is not ON. Firmly insert the plug into the outlet.
Incorrect power source/voltage. Make sure that the power supply/voltage
are correct.
The Fuse on the AC Unit has blown
due to momentary over current.
After eliminating the cause of overload,
replace the specied rating fuse.
The fuse of the connect board has
blown due to momentary over
current.
After eliminating the cause of overload,
replace the specied rating fuse.
Fluorescent lamp inside
Billboard Unit not
lighting
Connector connection fault. Check connections to the Billboard Unit.
Fluorescent lamp and glow lamp need
replacement.
Replace the uorescent lamp and the
glow lamp.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sega Grid 42 and is the answer not in the manual?

Sega Grid 42 Specifications

General IconGeneral
BrandSega
ModelGrid 42
CategoryArcade Game Machines
LanguageEnglish

Related product manuals