Expanding and assigning parameters to the device
6.5 Installing and removing an optional graphics card
104 Operating Instructions, 01/2021, A5E43920357-AA
Display message about opening firmware settings on the monitor of the optional graphics card
To configure the firmware, press the <Del> or <Esc> key when the boot message appears
during the boot phase of the device to access the firmware settings.
In delivery state the device is configured so that this message is only displayed on a monitor
that is connected to a DPP connection or DVI-D connection on the rear of the device, see
section "Device ports (Page 24)".
If you want to display this message on a monitor that is connected to an optional graphics
card connector, follow these steps.
1. Connect a monitor to the DPP port or the DVI-D port.
2. During the boot phase, when a boot message appears, press the <Del> or <Esc> button.
3. Select "Chipset" > "System Agent (SA) Configuration".
4. Assign the "Auto" value to the firmware setting "Primary Display".
6.5.2 Removing the optional graphics card
Requirement
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 48)".
• You have made a note of the firmware settings because the firmware settings of the
device can be deleted when the optional graphics card is removed.
You can find information on this in the firmware description of the device, see "Important
instructions and manuals for operating the device (Page 11)".
Procedure
1. The optional graphics card is an expansion card.
Remove the optional graphics card.
Note the information under "Removing expansion cards (Page 96)".
2. Check the firmware settings.
To Next Page
Loading...
Need help?
General
