Safety instructions
2.3 Safety instructions for assembly
Operating Instructions, 01/2021, A5E43920357-AA
43
Risk due to condensation
If the device is subjected to low temperatures or extreme fluctuations in temperature during
transportation, moisture could occur on or inside the HMI device (condensation).
Moisture can cause a short-circuit in electrical circuits and damage the device.
• Store the device in a dry place.
• Allow the device to warm up to room temperature before commissioning.
• Do not expose the device to direct heat radiation from a heating device.
• If condensation develops, wait approximately 12 hours or until the device is completely
dry before switching it on.
2.3 Safety instructions for assembly
Fire protection enclosure
the requirements for fire protection enclosures in accordance with
-2-201. It can therefore be installed without an additional fire protection
Approvals expire if the instructions are not observed
Approvals expire if the instructions are not observed
If the ambient and environmental conditions are not observed when installing and
operating the device or the system, the approvals according to IEC/EN/UL/CSA 61010-2-201
will become void.
There is a risk of overheating and personal injury.
Note the following instructions and information under:
• "Climatic and mechanical and ambient conditions (Page 150)"
"Safety instructions on ambient and environmental conditions (Page 45)"
To Next Page
Loading...
Need help?
General
