Expanding and assigning parameters to the device
6.6 Installing and removing drives
Operating Instructions, 01/2021, A5E43920357-AA
125
6.6.5 Installing drives in drive cage type C
6.6.5.1 Installation conditions for drives in the drive cage type C
Installation options for drives in the drive cage type C
You can mount drives in the following combination on the drive bay plate of the drive cage
type C:
• 1 x 3.5" HDD
• 2 x 3.5" HDDs
• 1 x 2.5" SSD
• 2 x 2.5" SSDs
• 1 x 3.5" HDD and 1 x 2.5" SSD
These drives are then built into the device and are not accessible from the outside.
• You can find information on the mounting locations under "Type C drive holder (Page 21)"
• You can find information on the procedure under "Install drives on the drive bay plate
(Page 125)".
6.6.5.2 Install drives on the drive bay plate
Requirement
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 48)".
• The device is equipped with a drive cage type C.
• You know the information under:
– Installation conditions for drives in the drive cage type C (Page 125)
• Original replacement parts, that is, drives approved for this device, see "Hardware
accessories (Page 35)".
• When installing 3.5" HDDs: T10 screwdriver
• When installing 2.5" SSDs: T8 screwdriver
Procedure
1. Fully disconnect the device from the line voltage, see "Switching off the device (Page 72)".
2. Open the device. Be sure to follow the important instructions under "Open the device
(Page 93)".
3. Remove the six screws for attaching or loosening the drive bay plate (see "Type C drive
holder (Page 21)") while holding the drive bay plate from the inside so that it does not fall
into the device when loosened.
4. Inside the device, remove the drive bay plate with the attached design cover.
5. Remove the design cover from the front of the drive bay plate.
To Next Page
Loading...
Need help?
General
