Siemens SIMOTICS CONNECT 400 User Manual

7.2 Operation with iOS
7.2.1 O󹪜boarding process using the "SIDRIVE IQ Con󹪝g" application
The process for detaching the connectivity module from the MindSphere application "SIDRIVE IQ
Fleet" is called "o󹪜boarding". All onboarding information in the connectivity module is deleted.
If you onboarded the asset under "SIDRIVE IQ Fleet" Version 2.0.0 or higher, no further input
is required. Under certain circumstances, e.g. if you carried out onboarding using an older
software version, you may also have to specify the tenant under which the asset is registered.
The o󹪜boarding process permanently deletes all data stored in "SIDRIVE IQ Fleet", as well as
the asset itself.
The asset instance used is released and is then available for onboarding a new asset under
the relevant tenant.
After o󹪜boarding, transmission of measurement data to "SIDRIVEIQFleet" is no longer
possible. To transfer data, start a new onboarding process.
O󹪜boarding is the precondition for a new onboarding process to "SIDRIVEIQFleet".
Requirements
• You have logged onto the connectivity module (Page78).
• The Wi-Fi connection has been set up. (Page82)
• The SIMOTICS Connect 400 connectivity module is registered with IQFleet. (Page98)
• You have the role "iq󹪞eet.o󹪜boarding" in "SIDRIVE IQ Fleet". If you do not have this role,
o󹪜boarding is canceled with an error message "Insu󹪟cient rights". Please contact your
"SIDRIVE IQ Fleet" Tenant Administrator.
Operation
7.2Operation with iOS
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL 121

Siemens SIMOTICS CONNECT 400 Specifications

General

Brand	Siemens
Model	SIMOTICS CONNECT 400
Category	Control Unit
Language	English