Siemens SIMOTICS CONNECT 400 User Manual

4.3 Requirements
Mobile device for the "SIDRIVE IQ Con󹪝g" application
To set up the connectivity module, install the "SIDRIVE IQ Con󹪝g" application on a mobile device.
The mobile device must satisfy the following requirements:
• Android operating system with Version ≥ 8.0 or iOS operating system with Version ≥ 13.0
• Functioning Internet connection
Download the "SIDRIVE IQ Con󹪝g" application from the Google Play Store (Page38) or the
Apple AppStore (Page74).
Mobile device with Bluetooth
The mobile device must have an integrated Bluetooth interface that supports the Bluetooth Low
Energy V4.1 standard - or a later standard.
Wi-Fi connection
The current version of the connectivity module does not support a proxy server con󹪝guration.
Use a direct Internet connection.
The connectivity module encrypts your data according to security standard WPA2. For data
transfer, the connectivity module supports Wi-Fi connections with a frequency of 2.4GHz
and the Wi-Fi standard 802.11b/g/n. Only Wi-Fi passwords with a maximum length of 32
characters are supported.
Note
The SIMOTICS CONNECT 400 connectivity module does not support Wi-Fi authentication
protocols according to IEEE 802.1X.
Ports that are used
Release the following ports used by SIMOTICS CONNECT 400 to allow an Internet connection to
be established:
• Secure data exchange with SIDRIVE IQ Fleet: TCP port 443
• Name resolution via DNS: TCP port 53; UDP port 53
• Time synchronization via NTP: UDP port 123
• IP address assigned via DHCP: TCP port 67, 68; UDP port 67, 68
• The mobile device 󹪝rmware is updated in the same Wi-Fi network: TCP port 9999
Preparations for use
4.3Requirements
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL 29

Siemens SIMOTICS CONNECT 400 Specifications

General

Brand	Siemens
Model	SIMOTICS CONNECT 400
Category	Control Unit
Language	English