Siemens SIMOTICS CONNECT 400 User Manual

8.5.2.5 Intervals - Step 4/7
In this step, you can de󹪝ne the intervals for measurements and data transfers. The remaining
battery life is recalculated based on your entry.
Note
Calculated battery life
The calculated battery life is a statistical value. The actual remaining battery life may di󹪜er
depending on temperature in󹪞uences or the connection quality of the Wi-Fi network.
Note
E󹪜ects that in󹪞uence the battery life
Shorter intervals result in a shorter battery life.
The following intervals are preset in the factory:
• 5 minutes - interval for measuring temperature, vibrations, rotational frequency, operating
status
You can change these settings within a speci󹪝ed range.
• 10 minutes - interval to calculate speed, torque and energy consumption
This interval cannot be set, it is dependent on the selected measurement interval. The
calculation interval is three times as long, i.e. 3 minutes, for a
measurement interval of 1 minute. The calculation interval is twice as long for
measurement intervals 2 and 5 minutes. The calculation interval is the same length for all
other measurement intervals.
• 24 hours - interval for transmission of the stored data to "SIDRIVE IQ Fleet"
You can modify these settings within a preset range of 1 to 48 hours.
Note
To calculate the bearing status, the measuring cycle must be set to ≳ 5 minutes.
Maintenance
8.5Replacing the connectivity module
SIMOTICS CONNECT 400
146 Operating Instructions, 04/2023, A5E50161952B AL

Siemens SIMOTICS CONNECT 400 Specifications

General

Brand	Siemens
Model	SIMOTICS CONNECT 400
Category	Control Unit
Language	English