Siemens SINUMERIK 802D Training Manual

Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 4
C81
C81
Section 3
Starting a Program
The machine builder may also state prerequisites, read the handbook of
the machine tool builder
It is possible
with Single Block, to process one block at a time. To execute
the whole part program this requires subsequent
presses of the NC Start
key
.
The SINGL
E BLOCK key can be found on the machine control panel:
The Automa
tic mode has to be selected priot to NC-Start.
Whether or not SINGLE BLOCK is active can be seen on the Status line of
the control,
as in the following diagram:
The SINGLE BLOCK function can be deactivated by pressing the key a
second time
.
The machine Stops at t
he end of the current block when the SINGLE
BLOCK key
is pressed in program.
The feedrate override can be used
additionally to control the velocity af the
axis.
Requirements prior to NC-Start.
NC-Start
Taking care of the above mentioned functions you can continue with the
Cycle Start key.
3.1 Starting a Program

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English