Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 2
C77
C77
Section 2
Creating a work plan
An example program will be created using the following workpiece:
The work plan is used to define the steps which have to be carried
out to machine the workpiece.
Working Ste
p Nr. Operation Tools
1
Surface milling End mill D60mm
2
Contour milling End mill D60mm
3
Slot milling Slot mill D6mm
The slot mill can cut on the side and on the face, it is therefore good for the
com
plete machining of slots.
2.1 Creating a work plan
To Next Page
Loading...
Need help?
General
