5-2. Multi Interface Shoe Block
5-2-1. FP-2269 Board
The FP-2269 flexible board contains a shoe connector (CN0001) to attach a handle and multi-interface shoe accessory.
5-2-2. ZM-1005 Board
The ZM-1005 board contains a load switch (Q8800, Q8801) and a power rectifier LDO (IC3802) to supply power to
the handle and the multi-interface shoe accessory. Only the ZOOM AD power in the handle is supplied through the load
switch (Q3801, Q3803). The system processor (IC6000) on the VC-1045 board controls (ON/OFF) both of these load
switches.
The operation information of the ZOOM SPEED switch, 2nd ZOOM lever, and 2nd SS button on the handle is transferred
to the system processor (IC6000) through the logic switch (IC3801). The system processor (IC6000) also controls (ON/
OFF) this logic switch. Signals from the multi-interface shoe are transferred from the 33-pin connector (CN4505) through
the ZM-1005 board, and are then output from the 61-pin connector (CN4502) to the VC-1045 board.
HXR-NX80/HXR-MC88
5-2