5-5-5. IP-1002 Board
The IP-1002 board contains an ASSIGN5 button (S4451). The operation information of this button is output in the
following route.
The 6-pin connector (CN4451) → 6-pin connector (CN4607) on the GR-1003 board → 39-pin connector (CN4601) →
39-pin connector (CN4507) on the ZM-1005 board → 61-pin connector (CN4501) → VC-1045 board
5-5-6. SW-1030 Board
The SW-1030 board contains a ZOOM/FOCUS switch (S1302) and an AF/MF button (S1301). The operation
information of these switch and button is output from the 6-pin connector (CN1301) to the VC-1045 board.
5-5-7. GR-1003 Board
The GR-1003 board receives the operation signal from the zoom lever (PZ96000) on the grip by the 6-pin connector
(CN4605), and then outputs this signal from the 39-pin connector (CN4601) through the 39-pin connector (CN4507)
and 61-pin connector (CN4501) on the ZM-1005 board to the VC-1045 board.
HXR-NX80/HXR-MC88
5-6