Section 3
Replacement of Main Parts
3-1. Tightening Torque
When tightening screws used in this unit, be sure to use a torque driver and tighten screws to the specified tightening
torque.
If the specified tightening torque is described in the figure in this section, tighten screws to the specified tightening
torque in the figure.
Tightening torque
Precision screw (P1.4 x 5): 0.10 ±0.02 N·m
Tapping screw (P1.4 x 4): 0.10 ±0.02 N·m
Precision screw (P1.7 x 4) (Except for cabinet G assembly and top ornament installation): 0.12 ±0.02 N·m
Precision screw (P1.7 x 4) (For cabinet G assembly and top ornament installation): 0.14 ±0.02 N·m
Tapping screw (P1.7 x 4) (For REC tally installation): 0.14 ±0.02 N·m
Tapping screw (P1.7 x 4) (Except for REC tally installation): 0.12 ±0.02 N·m
Tapping screw (P1.7 x 5) (Except for cabinet G assembly and eye cup installation): 0.12 ±0.02 N·m
Tapping screw (P1.7 x 5) (For cabinet G assembly): 0.14 ±0.02 N·m
Tapping screw (P1.7 x 5) (For eye cup installation): 0.16 ±0.02 N·m
Precision screw (P1.7 x 2.5): 0.12 ±0.02 N·m
Precision screw (P1.7 x 4): 0.12 ±0.02 N·m
M2.0 x 4: 0.18 ±0.02 N·m
Tapping screw (M2.0 x 5): 0.18 ±0.02 N·m
P2.6 x 5: 0.4±0.04 N·m
Tip
When using the torque driver with the notation of cN·m, interpret it as follows.
Example: 0.8 N·m = 80 cN·m
HXR-NX80/HXR-MC88
3-1