Sony HXR-NX80 - Inner Mold (T) Assembly Replacement

3-8. Inner Mold (T) Assembly
Preparation
1. Remove the cabinet (G) assembly. (Refer to “3-2. Cabinet (G) Assembly”.)
2. Remove the heat sink (GP) assembly. (Refer to “3-3. Heat Sink (GP) Assembly”.)
3. Remove the top cabinet assembly. (Refer to “3-5. Top Cabinet Assembly”.)
4. Remove the EF-1003 board. (Refer to “3-6. EF-1003 Board”.)
5. Remove the IR cabinet assembly. (Refer to “3-7. IR-1009 Board”.)
Procedure
1. Disconnect the flexible board from the connector (CN4003) on the VC-1045 board.
Flexible board
Arrangement of flexible board
CN4003
(VC-1045 board)
Note
When connecting the flexible board, push the flexible board as shown in the figure.
HXR-NX80/HXR-MC88
3-13