5-6. User Interface Terminal Block
5-6-1. LA-1003 Board
The LA-1003 board contains a REMOTE connector (J0901). The REMOTE accessory insertion/removal detect signal
and the accessory control signal are sent to/received from the power controller (IC5700) and the peripheral IC (IC5200)
on the VC-1045 board through the 10-pin connector (CN0901) via the 10-pin connector (CN4509) and 61-pin connector
(CN4501) on the ZM-1005 board.
5-6-2. IR-1009 Board
The IR-1009 board contains the following interface devices.
• Remote controller light-receiver (IC0801)
This IC receives signals from the infrared remote controller (RMT-845).
• Multi/micro USB connector/VIDEO OUT connector (CN0802)
These connectors are used for connection with accessories such as AV cable (VMC-15MR2) and remote
commander (RM-VPR1) and for USB communication with a personal computer.
• MIC connector (J0801)
This connector is used to connect an external microphone.
• Recording LED (D0801)
This LED blinks when the remaining capacity of the memory card or the battery level decreases.
• Nightshot light (D0802)
When the Nightshot light is ON and Nightshot is ON, the infrared light is turned on.
5-6-3. FP-2401 Flexible Board
The FP-2401 flexible board contains an HDMI-A connector (CN9101).
This board also contains a buffer IC (IC9102) for the DDC_SCL signal and the DDC_SDA signal.
HXR-NX80/HXR-MC88
5-7