110 VL1500K5 (’05-MODEL)
THROTTLE BODY INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following points:
• Connect the throttle pulling cable
1 and throttle returning
cable
2 to the throttle cable drum.
• Loosen each throttle cable lock-nut.
• Turn in each throttle cable adjuster fully and locate each outer
cable so that the clearance is 0 – 2 mm (0 – 0.08 in).
• Tighten each lock-nut.
• Adjust the throttle cable play.
Refer to page 9 for details.
AIR CLEANER BOX INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following points:
• Install the air cleaner box and tighten the throttle body clamp
screws as shown in the illustration.
STP SENSOR ADJUSTMENT
If the STP sensor adjustment is necessary, measure the sensor
resistance and adjust the STP sensor position as follows:
• Remove the air cleaner box. (!Page 103)
• Disconnect the STVA coupler and STP sensor coupler.
(!Page 74 and 77)
• Close the secondary throttle valve by finger, and measure the
STP sensor resistance.
" STP sensor setting resistance
ST valve is fully closed: Approx. 0.5 kΩ
(
+ Yellow –
- Black)
# 09900-25008: Multi-circuit tester set
) Tester knob indication: Resistance (Ω)
0 – 2 mm
(0 – 0.08 in)
0 – 2 mm
(0 – 0.08 in)
LEFT
SIDE
RIGHT
SIDE
VIEW OF TOP
Foward
Yellow
Black
SAMPLE
To Next Page
Loading...
Need help?
General
