VL1500K5 (’05-MODEL) 37
FAIL-SAFE FUNCTION
FI system is provided with fail-safe function to allow the engine to start and the motorcycle to run in a mini-
mum performance necessary even under malfunction condition.
The engine can start and can run even if the above signal is not received from each sensor. But, the engine
running condition is not complete, providing only emergency help (by fail-safe circuit). In this case, it is nec-
essary to bring the motorcycle to the workshop for complete repair.
When two ignition signals or two injector signals are not received by ECM, the fail-safe circuit can not work
and ignition or injection is stopped.
ITEM FAIL-SAFE MODE
STARTING
ABILITY
RUNNING
ABILITY
IAP sensor Intake air pressure is fixed to
760 mmHg.
“YES” “YES”
TP sensor The throttle opening is fixed to full
open position.
Ignition timing is also fixed.
“YES” “YES”
EOT sensor Engine oil temperature value is fixed
to 80 °C (176 °F).
“YES” “YES”
IAT sensor Intake air temperature value is fixed
to 40 °C (104 °F).
“YES” “YES”
Ignition signal #1 Ignition-off and #1 Fuel-cut “YES” “YES”
#2 cylinder can run.
#2 Ignition-off and #2 Fuel-cut “YES” “YES”
#1 cylinder can run.
Injection signal #1 Fuel-cut “YES” “YES”
#2 cylinder can run.
#2 Fuel-cut “YES” “YES”
#1 cylinder can run.
STV actuator Secondary throttle valve is fixed in
any position.When motor disconnec-
tion or lock occurs, power from ECM
is shut off.
“YES” “YES”
STP sensor Secondary throttle valve is fixed in
any position.
“YES” “YES”
Gear position signal Gear position signal is fixed to 5th
gear.
“YES” “YES”
HO2 sensor
(For E-02, 19, 24)
Feedback compensation is inhibited.
(Air/fuel ratio is fixed to normal.)
“YES” “YES”
PAIR control solenoid valve O2 feedback control is stopped and
PAIR valve is fixed to open position.
“YES” “YES”
SAMPLE
To Next Page
Loading...
Need help?
General
