5. Fuel Injection System
5-26
Error Code Message and Solution Operation
DTC
code
Flash
code
Service
priority
Message Solution operation
P0217 1 1
Engine
temperature
overheat
Stop the vehicle immediately, and solve it with priority.
Check the lubricant system for malfunction.
Check if the ignition or fuel supply system is in normal.
Check if the engine is burnt.
Make sure if the engine temperature sensor is in normal.
Make sure if the connector is in normal.
P0335 2 2
Abnormal
crankshaft
position sensor
Check if the connection of the crank position sensor is
open-circuit.
Check if the gap between the sensor and gear tooth is within
specification.
Check if the crank rotation is run-out.
Check if the sensor is in normal according to the new component
re
lacement
rocedure.
P0120 3 2
Abnormal
throttle position
sensor learning
value
Connect the diagnostic and reset the throttle valve position. Make
sure if the idle speed position is within standard range.
Make sure if the wire circuit of the throttle valve position sensor is
loosen or short.
Check if the openness of idle speed by-pass valve is within
specification. (40~100%)
Adjust the idle speed CO value to specified range. (0.5%~2.0%)
If this problem symptom still existing, check if the throttle position
sensor (TPS) is in normal according to the new component
replacement procedure.
P0121 4 2
Abnormal
throttle position
sensor output
voltage
Make sure if the wire circuit of the throttle valve position sensor is
loosen or short.
If this problem symptom still existing, check if the throttle position
sensor (TPS) is in normal according to the new component
replacement procedure.
P0124 5 2
Abnormal
throttle position
sensor turning
speed
Make sure if the wire circuit of the throttle valve position sensor is
loosen or short.
If this problem still existing, check if the throttle position sensor
(TPS) is in normal according to the new component replacement
procedure.
P0560 6 1
Abnormal
battery voltage
Make sure if the battery voltage is too low or high (below 10V or
exceed 16V)
Make sure if the ACG generator charging system circuit is short
or abnormal.
Check if the G4 terminal on the ECU to battery positive post is
short.
Make sure if the battery is in normal. Replace it with new if the
battery is out or order.
P0110
7 2
Abnormal intake
air temperature
sensor
Make sure if the sensor’s wire is in open-circuit.
Make sure if the sensor is normal according to the new
component replacement procedure.
To this chapter contents
To Next Page
Loading...
Need help?
General
