EM-108
ENGINE MECHANICAL - Cylinder Block
ASSEMBLY OF CYLINDER BLOCK
(See page EM-84)
HINT:
• Thoroughly clean all parts to be assembled.
• Before installing the parts, apply new engine oil to all
sliding and rotating surfaces.
• Replace all gaskets, O-rings and oil seals with new parts.
1. INSTALL NEW CYLINDER BLOCK OIL HOLE GASKET
2. INSTALL CYLINDER BLOCK ORIFICE
3. INSTALL OIL NOZZLES AND CHECK VALVES
(a) Align the pin of the oil nozzle with the pin hole of the
cylinder block.
(b) Install the oil nozzle with the check valve. Install the
five (1PZ) or six (1 HZ and 1HD-T) oil nozzles and
check valves.
Torque: 275 kg-cm (20 ft-lb, 27 Nm)
4. INSTALL MAIN BEARINGS
(a) Align the bearing claw with the claw groove of the
main bearing cap or cylinder block.
(b) Install the bearings in the cylinder block and main
bearing cap.
NOTICE: Install the bearing with the oil hole in the
cylinder block.
5. PLACE CRANKSHAFT ON CYLINDER BLOCK
To Next Page
Loading...
Need help?
General
