STARTING SYSTEM - Starter ST-19
Brush Holder
INSPECT BRUSH HOLDER INSULATION
Using an ohmmeter, check that there is no continuity
between the positive ( + ) and negative (-) brush holders.
If there is continuity, repair or replace the brush holder.
Clutch and Gears
1. INSPECT GEAR TEETH
Check the gear teeth on the pinion gear, idler gear and the
clutch assembly for wear or damage.
If damaged, replace the gear or clutch assembly.
If damaged, also check the flywheel ring gear for wear or
damage.
2. INSPECT CLUTCH PINION GEAR
Rotate the pinion gear clockwise and check that it turns
freely. Try to rotate the pinion gear counterclockwise and
check that it locks.
If necessary, replace the clutch assembly.
3. IF NECESSARY, REPLACE CLUTCH ASSEMBLY
A. Disassembly starter housing and clutch assembly
(a) Push down the pinion gear and starter housing.
(b) Using a plastic-faced hammer, tap in the stop collar.
(c) Using a screwdriver, pry out the snap ring.
To Next Page
Loading...
Need help?
General
