FUEL SYSTEM - Injection Pump FU-57
(b) Install the following parts to the pump plunger:
(1) Lower plunger plate
(2) Upper plunger plate
(3) Lower spring seat
(4) Spill ring
HINT: Face the spill ring with the hole facing the lower
spring seat.
(c) Align the pin groove of the plunger with the pin of the
face camplate.
(d) Align the ball pin of the governor link with the pin hole
of the spill ring.
(e) Using SST, install the pump plunger and two plunger
springs.
SST 09260-5401 2 (09269-54030)
16. INSTALL DISTRIBUTIVE HEAD
(a) Apply No.50 DENSO grease to the following parts
and install them to the distributive head:
(1) Two plunger spring guides
(2) Two new selected plunger spring shims
(3) Two upper spring seats
(4) Two lever support springs
(5) New O-ring
(b) Install the distributive head.
NOTICE: Be careful not to damage the pump
plunger.
(c) Using 5 mm hexagon wrench, install the four bolts.
Torque: 120 kg-cm (9 ft-lb, 12 Nm)
HINT: Use the bolt which is 45 mm (1.77 in.) in length.
To Next Page
Loading...
Need help?
General
