EM-77
ENGINE MECHANICAL Cylinder Head
2. SET N0.1 CYLINDER TO BDC
Turn the crankshaft pulley, and align the BDC mark of the
timing gear cover with the No.1 flange groove of the No.2
camshaft timing pulley.
3. INSTALL CYLINDER HEAD
A. Place cylinder head on cylinder block
(a) Place a new cylinder head gasket in position on the
cylinder block.
NOTICE: Be careful of the installation direction.
(b) Place the cylinder head in position on the cylinder
head gasket.
B. Install cylinder head bolts
HINT:
• The cylinder head bolts are tightened in three progressive
steps.
• If any of bolts break or deform, replace them.
(a) Apply a light coat of engine oil on the threads and
under the heads of the cylinder head bolts.
(b) First, using SST, install and uniformly tighten the
twenty-two cylinder head bolts (1 PZ) or twenty-six
cylinder head bolts (1 HZ and 1HD-T) in several
passes in the sequence shown.
SST 09011 -38121
Torque: 700 kg-cm (51 ft-lb, 69 N m)
If any one of the bolts does not meet the torque specifica-
tion, replace the bolt.
(c) Mark the front of the cylinder head bolt head with
paint.
To Next Page
Loading...
Need help?
General
