FU-36 FUEL SYSTEM Injection Pump
(c) Disconnect the speed control spring from the spring
seat, and remove the spring seat, damper spring,
speed control spring, the governor cover and adjust-
ing lever shaft assembly and gasket.
14. REMOVE GOVERNOR ADJUSTING LEVER SHAFT
FROM GOVERNOR COVER
Remove the following parts from the governor cover.
(1) Adjusting lever shaft, O-ring and washer
assembly
(2) O-ring
(3) Washer
15. (1PZ(w/HAC) and1HZ(w/HAC))
DISASSEMBLE HIGH ALTITUDE COMPENSATOR
A. Remove lever control spring
Remove the bolt, gasket and lever control spring.
B. Remove pneumatic bellows
(a) Using a 5 mm hexagon wrench, remove the four bolts.
To Next Page
Loading...
Need help?
General
