Toyota 3S-GTE User Manual

EG-42
ENGINE — ENGINE MECHANICAL
I Ax .
\\\'=‘-.
wԤ-\
CYLINDER HEAD REMOVAL
(See Components for Removal and Installation)
1. DRAIN ENGINE COOLANT
2. REMOVE INTERCOOLER
(See steps 3 and 5 on page EG—88)
3. REMOVE DISTRIBUTOR
kg O (a) Disconnect the distributor connector.
i
/‘--..
M8286
,5
‘~
(b) Remove the 2 bolts and cool air inlet.
li
/<3’ t
Y
I
t_/J
4 Q‘
/
Q \
£O)<\ I J
PIBQIQ
~» Q lc) Remove the 3 bolts, and disconnect the high—tension
Q 1 cord clamp from the cylinder head cover.
\\\)
(d) Disconnect the high —tension cords at the rubber
/ // '% I) o ull th hi h—- ' rd
§ (\cORHECT mi oot. o not p on e g tension co s.
__ F\ NOTICE: Pulling on or bending the cords may damage the
\ A ~ f t WRONG- . .
9 Q go conductor inside
R t /X I
/
<
\
‘A,
PI8287

Toyota 3S-GTE Specifications

General

Brand	Toyota
Model	3S-GTE
Category	Engine
Language	English