Ublox SARA-R4 Series User Manual

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

10V24 control and V25ter
Page 105 of 307
10.15Pause before blind dialling S6
S6
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial No No No - +CME Error
10.15.1Description
Specifies the time in seconds that the DCE waits between connecting to the line and dialling, when the dial
tone is not implemented or enabled. The command is not applicable for signal based mobile phone software.
10.15.2Syntax
Type Syntax Response Example
Set ATS6=<value> OK ATS6=2
OK
Read ATS6? <value>
OK
002
OK
10.15.3Defined values
Parameter Type Description
<value> Number Range 2 - 10. The answer to the read command is in "xxx" format. The default value is
2 s.
10.16Connection completion timeout S7
S7
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial No Profile No - +CME Error
10.16.1Description
Specifies the time in seconds, that the DCE shall allow between either answering a call or completion of dialling
and establishment of a connection with a remote site.
10.16.2Syntax
Type Syntax Response Example
Set ATS7=<value> OK ATS7=30
OK
Read ATS7? <value>
OK
060
OK
10.16.3Defined values
Parameter Type Description
<value> Number Range 1 - 255. The answer to the read command is in "xxx" format. The default and
the factory-programmed value is 60 s.

Ublox SARA-R4 Series Specifications

General

Brand	Ublox
Model	SARA-R4 Series
Category	Control Unit
Language	English