SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

5Mobile equipment control and status
Page 36 of 307
5.9î™–î™–î™–î™–Report mobile termination error +CMEE
+CMEE
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full No No No - +CME Error
5.9.1î™–î™–î™–î™–Description
Configures the formatting of the result code +CME ERROR: <err> as an indication of an error relating to the
functionality of the MT. When enabled, MT related errors cause +CME ERROR: <err> final result code instead
of the regular ERROR final result code. The error result code is returned normally when an error is related to
syntax, invalid parameters or MT functionality.
5.9.2î™–î™–î™–î™–Syntax
Type Syntax Response Example
Set AT+CMEE=[<n>] OK AT+CMEE=2
OK
Read AT+CMEE? +CMEE: <n>
OK
+CMEE: 0
OK
Test AT+CMEE=? +CMEE: (list of supported <n>s)
OK
+CMEE: (0-2)
OK
5.9.3î™–î™–î™–î™–Defined values
Parameter Type Description
<n> Number
• 0: +CME ERROR: <err> result code disabled and ERROR used
• 1: +CME ERROR: <err> result code enabled and numeric <err> values used
• 2: +CME ERROR: <err> result code enabled and verbose <err> values used
5.9.4î™–î™–î™–î™–Notes
• The following convention is valid:
Numeric error code Verbose error code Description
3 "operation not allowed" The MT is in a state which does not allow performing the
entered command.
4 "operation not supported" The error result code is related to a parameter not covered by
the GSM/ETSI or u-blox specification
To Next Page
Loading...
Need help?
General
