Ublox SARA-R4 Series - Page 201

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

18Internet protocol transport layer
Page 201 of 307
18.23.3Defined values
Parameter Type Description
<socket> Number Socket identifier. The range goes from 0 to 6
<param_id> Number Control request identifier. Possible values are:
• 0: query for socket type
• 1: query for last socket error
• 2: get the total amount of bytes sent from the socket
• 3: get the total amount of bytes received by the socket
• 4: query for remote peer IP address and port
• 10: query for TCP socket status (only TCP sockets)
• 11: query for TCP outgoing unacknowledged data (only TCP sockets)
• 5-9, 12-99: RFU
<param_val> Number /
String
This value may assume different means depending on the <param_id> parameter.
If <param_id>= 0, <param_val> can assume these values:
• 6 TCP socket
• 17: UDP socket
If <param_id>= 1, <param_val> can assume these values:
• N: last socket error
If <param_id>= 2, <param_val> can assume these values:
• N: the total amount (in bytes) of sent (acknowledged + unacknowledged) data
If <param_id>= 3, <param_val> can assume these values:
• N: the total amount (in bytes) of received (read) data
If <param_id>= 4, <param_val> can assume these values:
• A string representing the remote peer IP address expressed in dotted decimal form
If <param_id>= 10, <param_val> can assume these values:
• 0: the socket is in INACTIVE status (it corresponds to CLOSED status defined in
RFC793 "TCP Protocol Specification" [112])
• 1: the socket is in LISTEN status
• 2: the socket is in SYN_SENT status
• 3: the socket is in SYN_RCVD status
• 4: the socket is in ESTABILISHED status
• 5: the socket is in FIN_WAIT_1 status
• 6: the socket is in FIN_WAIT_2 status
• 7: the sokcet is in CLOSE_WAIT status
• 8: the socket is in CLOSING status
• 9: the socket is in LAST_ACK status
• 10: the socket is in TIME_WAIT status
If <param_id>= 11, <param_val> can assume these values:
• N: the total amount of outgoing unacknowledged data
<param_val2> Number This value is present only when <param_id> is 4. It represents the remote peer IP port.
For IP address format reference see the IP addressing.
18.23.4Notes
SARA-R4 / SARA-N4
• <param_id>= 2, 3, 4 and 11 are not supported.