Whirlpool Cabrio WTW8500DC - Load and Test Cycle Function Numbers Chart

DIAGNOSTICS & TROUBLESHOOTING
Whirlpool 2014 CABRIO
®
Direct Drive Washer
n
5-5
For Service Technician Use Only
Display Funcon Notes
000 Toggle Lid Lock Note: To lock or unlock the lid, all loads (pumps, motor, valves, and
heater) must be o and the lid must be closed.
001 Toggle Cold Valve
002 Toggle Hot Valve
003 Toggle Fresh Fill Valve N/A
004 Toggle Detergent Valve N/A
005 Toggle Fabric Soener Valve For water to ow, cold water should be turned on rst. Note: If the fabric
soener valve is turned “ON” without the cold water valve “ON”, water
can overow the front of the tray.
006 Toggle Oxi Valve For water to ow, hot water should be turned on rst. Note: If the
Oxi valve is turned “ON” without the hot water valve “ON”, water can
overow the front of the tray. Note: Oxi not available on all models.
007 Toggle Bleach Valve Note: On models with dump bleach dispenser, toggling this load will turn
on the Oxi valve.
008 Toggle Drain Pump
009 Toggle Recirc. Pump Note: Not available on all models.
010 Toggle Low Speed Spin Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this funcon.
011 Toggle Mid Speed Spin Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this funcon.
012 Toggle High Speed Spin Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this funcon.
013 Toggle Slow Agitate Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this funcon.
014 Toggle Fast Agitate Lid must be closed and locked for this to be enabled. Note: The basket
must be empty for this funcon.
015 Toggle Shier Switch in and out of Spin. Shier On = Spin and Shier O = Agitate.
Note: This can only be commanded while the motor is not running. The
shier will also be on when spin funcons 10–12 are acve.
016 Toggle Basket Light N/A
017 Toggle Heater Note: To actuate the heater, all loads (pumps, motor, and valves) must be
o and water level must be above the impeller.
050 Run Factory Calibraon Note: For factory test only.
051 Service Diagnoscs Service Diagnoscs for repair vericaon and installaon
vericaon.
052 Run Service Calibraon This calibrates the main control to the washer for opmal load size
sensing. Upon compleon, the UI will display 000. The Soil Level and
Temp buons can be used to review step results if Pass/Fail criteria exist.
If a step has no Pass/Fail criteria, --- will be displayed.
053 Run Dry Factory Calibraon Note: For factory test only.
075 Set Life Test Mode Note: For factory test only. If life test mode is accidentally acvated, Life
Test can be exited by removing power from the washer and waing for
the control to power down as indicated by the diagnosc LED ceasing to
ash (5-3).
Load and Test Cycle Funcon Numbers Chart
NOTE: Some loads will not be available on all models