Machine Parts and Connection Ports
Xerox WorkCentre 3315DN/3325DN/3325DNI
System Administrator Guide
21
Configure Ethernet Settings
The Ethernet interface will automatically detect the speed of your network. The machine supports
hub/switch speeds of:
•Automatic
• 10 Mbps Full-Duplex
• 100 Mbps Full-Duplex
• 10 Mbps Half-Duplex
•100 Mbps Half-Duplex
• 1 Gbps Full
Set the Ethernet speed on the machine to match the speed set on your hub or switch:
Setting the Ethernet Speed at the Machine
1. Press the Machine Status button.
2. Press the Up/Down arrow buttons to highlight Network Settings and press OK.
3. Enter the Administrator Password using the alphanumerical keypad. The default is 1111. Refer to
Administrator Access on page 19.
4. Press the Up/Down arrow buttons to highlight Ethernet Speed and press OK.
5. Press the Up/Down arrow buttons to highlight one of the following speeds:
•Automatic
•10 Mbps Half
•10 Mbps Full
•100 Mbps Half
•100 Mbps Full
• 1 Gbps Full
6. Press OK. The Saved screen displays followed by the Reboot Required message.
To reboot the machine, press the power switch off, wait two seconds and press the power switch
back on.
To set the Ethernet Speed using Internet Services, refer to Setting the Ethernet Speed Using Internet
Services on page 26.
Print a Configuration Report
The Configuration Report details the machine software versions and network settings configured for
the machine.
Print a Configuration Report at the Machine
1. Press the Machine Status button.
2. Press the Up/Down arrow buttons to highlight Information Pages and press OK.
3. Press the Up/Down arrow buttons to highlight Configuration Page and press OK.
To Next Page
Need help?
General
