Unix
Xerox WorkCentre 3315DN/3325DN/3325DNI
System Administrator Guide
36
6. Enter Exit to exit Super User mode.
7. Test the queue created, by entering the command:
lp -d queuename /etc/hosts.
8. Verify that the job prints at the machine.
SCO
SCO UNIX workstations require specific installation steps to communicate with the machine. The
machines are BSD-style UNIX printers, whereas SCO is a System V-style UNIX.
Information Checklist
Before starting please ensure that the following items are available and/or the tasks have been
performed:
• Existing operational network utilizing the TCP/IP protocol.
• Ensure that the machine is connected to the network.
• Static IP Address for the machine.
• Subnet Mask Address for the machine.
• Gateway Address for the machine.
• Host Name for the machine.
Procedure
Follow the steps in Configure Static IPv4 Addressing using the Machine User Interface on page 28,
then return to this page.
Configure the Client
1. Add the machine printer Host name to the etc/hosts file on the SCO workstation.
2. Ensure that you can ping the machine from the SCO workstation.
Perform the following steps to create a machine print queue on a SCO UNIX workstation using
either the GUI or the TTY method.
GUI Method
1. Log in as root.
2. From the main desktop, select the icons System Administration: Printers: Printer Manager.
3. Select Printer: Add Remote: UNIX....
4. Enter the following information into the Add Remote UNIX Printer form:
a. Host: hostname.
Where hostname is the machine Host Name from the /etc/hosts file.
b. Printer: name of the queue being created.
For example: dc xxxq.
c. Select OK to complete the form.
5. Select OK in the Message window.
6. Select Host:Exit.
To Next Page
Loading...
Need help?
General
