Security
WorkCentre 7120/7125 Multifunction Printer
System Administrator Guide
58
Certificate Revocation Retrieval Settings
1. In CentreWare IS, click Properties > Security > Certificate Revocation Settings.
2. Under General, select the Level of Certificate Verification.
• Low: The revocation status of certificates is not checked. The printer verifies that the
certificate has not expired, and the certificate issuer and signature are valid.
• Medium: The revocation status of certificates is checked. If the certificate status cannot be
obtained due to a network error, the certificate is still considered valid.
• High: The revocation status of certificates is checked. The certificate is only considered valid
after successfully verifying that the certificate has not been revoked.
3. Under General, select the Retrieval of Certificate Status.
4. If you selected OCSP as the retrieval method, under OCSP, next to Send Query to OCSP
Responder With, select URL as Specified in Certificate or URL as SPecified by Administrator.
5. Type the URL of OCSP Responder
6. Type the OCSP Communication Time-Out (5-60 seconds).
7. If you selected CRL as the retrieval method, under CRL, next to Auto Retrieval of CRL, select
Enabled if desired.
8. Type the CRL Retrieval Time-Out (5-60 seconds).
9. Click Apply to accept the changes or Undo to retain the previous settings.
To Next Page
Loading...
Need help?
General
