Instruments and indicators
40
Stop the engine immediately if the buzzer
sounds and the low oil pressure-alert indica-
tor blinks. Check the engine oil quantity and
replenish oil if necessary. If the alert device
has activated while the appropriate engine oil
quantity is maintained, consult your Yamaha
dealer.
ECM01602
Do not continue to run the engine if the
low oil pressure alert device has activated.
Serious engine damage will occur.
EMU36222
Overheat alert
If the engine temperature rises too high while
cruising, the overheat-alert indicator will start
to blink. The engine speed will automatically
decrease to about 2000 r/min.
Stop the engine immediately if the buzzer
sounds and the overheat alert device has ac-
tivated. Check the cooling water inlet for
clogging.
ECM01593
Do not continue to run the engine if the
overheat-alert indicator blinks. Serious
engine damage will occur.
Do not continue to operate the engine if
a alert device has activated. Consult
your Yamaha dealer if the problem can-
not be located and corrected.
EMU36151
Water separator alert
This indicator will blink if water has accumu-
lated in the water separator (fuel filter) while
cruising. In such an event, stop the engine
immediately and see page 92 of this manual
to drain the water from the fuel filter. Get back
to the port soon and consult a Yamaha dealer
immediately.
U6D63EE0.book Page 40 Friday, December 12, 2014 9:39 AM
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
