EasyManuals Logo

Yamaha F75 User Manual

Yamaha F75
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
Maintenance
75
2. Drain the cooling water completely out of
the outboard motor. Clean the body
thoroughly.
EMU28462
Checking painted surface of outboard
motor
Check the outboard motor for scratches,
nicks, or flaking paint. Areas with damaged
paint are more likely to corrode. If necessary,
clean and paint the areas. A touch-up paint is
available from your Yamaha dealer.
EMU44950
Periodic maintenance
WARNING
EWM01872
These procedures require mechanical
skills, tools, and supplies. If you do not
have the proper skills, tools, or supplies to
perform a maintenance procedure, have a
Yamaha dealer or other qualified mechan-
ic do the work.
The procedures involve disassembling the
motor and exposing dangerous parts. To
reduce the risk of injury from moving, hot,
or electrical parts:
Turn off the engine and keep the key(s)
and engine shut-off cord (lanyard) with
you when you perform maintenance un-
less otherwise specified.
The power trim and tilt switches operate
even when the ignition key is off. Keep
people away from the switches whenev-
er working around the motor. When the
motor is tilted, keep away from the area
under it or between it and the clamp
bracket. Be sure no one is in this area
before operating the power trim and tilt
mechanism.
Allow the engine to cool before handling
hot parts or fluids.
Always completely reassemble the mo-
tor before operation.
Maintenance, replacement, or repair of
the emission control devices and systems
may be performed by any marine engine
repair establishment or individual. All war-
ranty repairs, however, including those to
the emission control system, must be per-
formed by an authorized Yamaha marine
dealership.
For North America:
A service manual is available for purchase
through your Yamaha dealer for owners who
have the mechanical skills, tools, and other
equipment necessary to perform mainte-
nance not covered by this owner’s manual.
EMU28512
Replacement parts
If replacement parts are necessary, use only
genuine Yamaha parts or parts of equivalent
design and quality. Any part of inferior quality
may malfunction, and the resulting loss of
control could endanger the operator and pas-
sengers. Yamaha genuine parts and acces-
sories are available from your Yamaha dealer.
EMU35522
Maintenance interval guidelines
The service intervals provided in the Mainte-
nance Chart were developed based upon
“typical” use that includes operating at varied
speeds, with sufficient time for engine warm
1. Air intake
1
ZMU07861
U6D63EE0.book Page 75 Friday, December 12, 2014 9:39 AM
©2019 Yamaha Motor Corporation, U.S.A.

Table of Contents

Other manuals for Yamaha F75

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha F75 and is the answer not in the manual?

Yamaha F75 Specifications

General IconGeneral
Cylinders4
Fuel Induction SystemEFI (Electronic Fuel Injection)
Prop Shaft Horsepower75 hp
Full Throttle RPM Range5000-6000 RPM
Gear Ratio2.15:1
Starting SystemElectric
Engine Type4-stroke
Alternator Output25A
Steering Angle35° from center, either direction
Shaft Length20 in., 25 in.
Fuel Tank CapacityN/A (External)
Recommended FuelRegular Unleaded (Minimum Pump Octane 87)
Warranty3-Year Limited Warranty

Related product manuals