EasyManuals Logo

Yamaha F75 User Manual

Yamaha F75
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
Maintenance
81
NOTICE
ECM00491
This procedure must be performed while
the outboard motor is in the water. A flush-
ing attachment or test tank can be used.
If the boat is not equipped with a tachometer
for the outboard motor, use a diagnostic ta-
chometer for this procedure. Results may
vary depending on whether testing is con-
ducted with the flushing attachment, in a test
tank, or with the outboard motor in the water.
1. Start the engine and allow it to warm up
fully in neutral until it is running smoothly.
2. Once the engine has warmed up, verify
whether the idle speed is set to specifi-
cation. For idle speed specifications, see
page 14. If you have difficulty verifying
the idle speed, or the idle speed requires
adjustment, consult a Yamaha dealer or
other qualified mechanic.
EMU38807
Changing engine oil
WARNING
EWM00761
Avoid draining the engine oil immediate-
ly after stopping the engine. The oil is
hot and should be handled with care to
avoid burns.
Be sure the outboard motor is securely
fastened to the transom or a stable
stand.
NOTICE
ECM01711
Change the engine oil after the first 20
hours of operation or 3 months, and every
100 hours or at 1-year intervals thereafter.
Otherwise the engine will wear quickly.
To prevent spilling oil where it could cause
damage to nature, it is strongly recommend-
ed that you use an oil changer to change the
engine oil. If an oil changer is not available,
drain the engine oil by removing the drain
screw. If you are not familiar with the proce-
dure for changing the engine oil, consult your
Yamaha dealer.
1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
2. Start the engine. Warm it up and keep
the idle speed for 5-10 minutes.
3. Stop the engine and leave it for 5-10 min-
utes.
4. Remove the top cowling.
5. Remove the oil filler cap. Pull out the dip-
stick and use the oil changer to extract
the oil completely.
1. Oil filler cap
ZMU04270
1
ZMU04271
U6D63EE0.book Page 81 Friday, December 12, 2014 9:39 AM
©2019 Yamaha Motor Corporation, U.S.A.

Table of Contents

Other manuals for Yamaha F75

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha F75 and is the answer not in the manual?

Yamaha F75 Specifications

General IconGeneral
Cylinders4
Fuel Induction SystemEFI (Electronic Fuel Injection)
Prop Shaft Horsepower75 hp
Full Throttle RPM Range5000-6000 RPM
Gear Ratio2.15:1
Starting SystemElectric
Engine Type4-stroke
Alternator Output25A
Steering Angle35° from center, either direction
Shaft Length20 in., 25 in.
Fuel Tank CapacityN/A (External)
Recommended FuelRegular Unleaded (Minimum Pump Octane 87)
Warranty3-Year Limited Warranty

Related product manuals