Yamaha F75 User Manual

Engine control system
45
EMU26804
Alert system
NOTICE
ECM00092
Do not continue to operate the engine if a
alert device has activated. Consult your
Yamaha dealer if the problem cannot be
located and corrected.
EMU2681D
Overheat alert
This engine has an overheat-alert device. If
the engine temperature rises too high, the
alert device will activate.
 The engine speed will automatically de-
crease to about 2000 r/min.
 The overheat-alert indicator will light or
blink.
 The buzzer will sound (if equipped on the
tiller handle, remote control box, or main
switch panel).
If the alert system has activated, stop the en-
gine and check the cooling water inlets:
 Check trim angle to be sure that the cooling
water inlet is submerged.
 Check the cooling water inlet for clogging.
EMU26859
Low oil pressure alert
If the oil pressure drops too low, the alert de-
vice will activate.
 The engine speed will automatically de-
crease to about 2000 r/min. The low oil
pressure-alert indicator will light or blink.
ZMU01757
ZMU02630
ZMU01828
U6D63EE0.book Page 45 Friday, December 12, 2014 9:39 AM
©2019 Yamaha Motor Corporation, U.S.A.

Yamaha F75 Specifications

General

Cylinders	4
Fuel Induction System	EFI (Electronic Fuel Injection)
Prop Shaft Horsepower	75 hp
Full Throttle RPM Range	5000-6000 RPM
Gear Ratio	2.15:1
Starting System	Electric
Engine Type	4-stroke
Alternator Output	25A
Steering Angle	35° from center, either direction
Shaft Length	20 in., 25 in.
Fuel Tank Capacity	N/A (External)
Recommended Fuel	Regular Unleaded (Minimum Pump Octane 87)
Warranty	3-Year Limited Warranty