Yamaha F75 User Manual

Operation
63
2. After the engine is at idle speed in gear
move the remote control lever / gear shift
lever firmly and crisply into the neutral
position.
EMU31743
Stopping boat
WARNING
EWM01511
 Do not use the reverse function to slow
down or stop the boat as it could cause
you to lose control, be ejected, or im-
pact the steering wheel or other parts of
the boat. This could increase the risk of
serious injury. It could also damage the
shift mechanism.
 Do not shift into reverse while traveling
at planing speeds. Loss of control, boat
swamping, or damage to the boat could
occur.
The boat is not equipped with a separate
braking system. Water resistance stops it af-
ter the throttle lever is moved back to idle.
The stopping distance varies depending on
gross weight, water surface conditions, and
wind direction.
EMU30881
Trolling
EMU30891
Adjusting trolling speed
The trolling speed on outboard motors
equipped with the variable trolling RPM
switches can be adjusted approximately 50
r/min with each press of a switch.
U6D63EE0.book Page 63 Friday, December 12, 2014 9:39 AM
©2019 Yamaha Motor Corporation, U.S.A.

Yamaha F75 Specifications

General

Cylinders	4
Fuel Induction System	EFI (Electronic Fuel Injection)
Prop Shaft Horsepower	75 hp
Full Throttle RPM Range	5000-6000 RPM
Gear Ratio	2.15:1
Starting System	Electric
Engine Type	4-stroke
Alternator Output	25A
Steering Angle	35° from center, either direction
Shaft Length	20 in., 25 in.
Fuel Tank Capacity	N/A (External)
Recommended Fuel	Regular Unleaded (Minimum Pump Octane 87)
Warranty	3-Year Limited Warranty