5 Checks after start-up
88
5. Use the joysticks to extend and retract the bucket and arm cylinders to the end of their run.
Alternately run the bucket cylinder for 30 seconds then the arm cylinder for 30 seconds over
a total duration of around 5 minutes to raise the hydraulic oil temperature to at least 20°C.
IMPORTANT
When moving the accessory, make sure it does not hit the ground or the machine.
IMPORTANT
Check that there is no abnormal noise in the hydraulic circuit.
6. Check the colour of the exhaust gas, the noise and the vibrations of the machine.
7. Raise the locking lever to ensure that no handling of the equipment and no rotation of the
upper structure is possible with the joysticks.
8. Unlock the locking lever and activate the joysticks to check that everything is operating
normally.
9. If you observe the slightest anomaly during this procedure, contact your dealer.
To Next Page
Loading...
Need help?
General
