100
10 HANDLING THE BUCKET
10.1 Machine stability when using with a bucket or an
accessory
• The maximum weight when in use in bucket mode or with accessories that ensures machine
dynamic stability in use. It corresponds to the maximum weight allowed at the end of the
empty arm.
•
This weight is determined for the machine on a flat and firm ground under the most unfa-
vourable conditions and is indicated in the table below.
2 Lifting Cabin, page 170
1620 mm
-
365
-
410
-
1 Lifting ViO38-6 Canopy, page 169
1620 mm
-
350
-
395
-
• It must absolutely be taken into account by the operator before using the machine for exca-
vation, levelling operations or in working conditions with the accessories.
• Depending on the machine configuration (arm length, presence of a counterweight…) and
working conditions, the operator must make sure that:
– the equipment and accessories selection is made according to the nature of the task to
be carried out and according to the machine's stability limits.
– the total weight of the quick hitch, the accessories used (bucket, hydraulic hammer...)
and the load handled does not exceed the maximum weight allowed.
DANGER
Any excess can lead to a loss of stability of the machine and tip it over. YANMAR
CONSTRUCTION EQUIPMENT EUROPE S.A.S. accepts no responsibility in case of
non compliance with the safety instructions described in this chapter.
To Next Page
Loading...
Need help?
General
