2 Usage precautions
68
2.2 Movement precautions
2.2.1 Machine's Danger Zone
DANGER
The operator must manipulate the machine controls from the operator seat. Any use of
the machine controls from the ground is strictly prohibited because it can lead to physi-
cal injury.
WARNING
Start the engine and run the machine only from the operator seat.
• A signaller must be provided when the working site
is dangerous or has poor visibility.
• Keep all other people away from the working site
or movement route of the machine.
• Keep any other persons out of the danger zone re-
presented by the equipment's operating radius.
Equipment operating range = 6 m
• Alert people nearby using the horn or any other si-
gnal before starting the machine.
DANGER
If a person is in the machine's danger zone, it may be struck by the machine's moving
parts or be wedged between the machine's lower and upper parts, which can result in se-
rious injury or death.
2.2.2 Movement and accessories
• When moving the machine, keep the bucket bet-
ween 40 and 50 cm above the ground with the boom
and arm folded .
• If you need to use the command levers when mov-
ing, do not make any sudden movements when ope-
rating them.
• Move the machine at low speed and slow down
when turning on hilly terrain.
• Avoid driving over obstacles if possible. Avoid
them or remove them. If this is not possible, drive the
machine at low speed keeping the tool near the
ground.Never travel over obstacles that risk tilting the
machine by over 10 degrees.
To Next Page
Loading...
Need help?
General
