17 If the battery is discharged
123
17.3 Starting the engine
1. Check that the cables are connected safely to the battery terminals.
2. Start the engine on the repair machine and increase the engine speed to maximum.
3. Turn the starter switch of the machine that has broken down to START to start the engine.
If the engine does not start, wait at least two minutes before trying again. Do not stop the en-
gine on the repair machine and keep the engine speed at full rate.
17.4 Disconnecting the starter cables
• After starting the engine on the machine that has broken down, disconnect the starter cables
in reverse order to the connection procedure.
BS = backup battery
BP = battery broken down
MP = machine engine broken down
1. Remove the clip of the black starter cable (B) from
the engine block of the machine that has broken
down.
2. Remove the clip of the black starter cable (B) from
the negative terminal of the battery on the repairing
machine.
3. Remove the clip of the red starter cable (A) from
the positive terminal of the battery on the repairing
machine.
4. Remove the clip of the red starter cable (A) from
the positive terminal of the battery on machine that
has broken down.
To Next Page
Loading...
