YASKAWA Varispeed f7 User Manual

6-150
 Copying Constants
The Digital Operator can perform the following three functions using the built-in EEPROM (non-volatile
memory).
• Store Inverter constant set values in the Digital Operator (READ)
• Write constant set values stored in the Digital Operator to the Inverter (COPY)
• Compare constant set values stored in the Digital Operator with Inverter constants (VERIFY)
Related Constants
COPY Function Selection (SPEC: E or Later Only)
The available COPY functions (o3-01 “Copy function selection”) differ depending on the SPEC of Inverter as
shown in the table below.
* The initial values of user constants that have been stored using the constant o2-03 cannot be copied.
Con-
stant
Number
Name Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
MEMO
BUS
Regis-
ter
V/f
V/f
with
PG
Open
Loop
Vec-
tor
Flux
Vec-
tor
o3-01
Copy func-
tion selection
0: Normal operation
1: READ (Inverter to Operator)
2: COPY (Operator to Inverter)
3: Verify (compare)
0 to 3 0 NoAAAA515H
o3-02
Read permit-
ted selection
0: Read prohibited
1: Read permitted
0 or 1 0 No A A A A 516H
READ Source
Inverter with
SPEC: C or
earlier
(PRG:101)
Inverter with
SPEC: C or
earlier
(PRG:101)
Inverter with
SPEC: E or
earlier
(PRG:103)
Inverter with
SPEC: E or
earlier
(PRG:103)
COPY Destination
Inverter with
SPEC: C or
earlier
(PRG:101)
Inverter with
SPEC: E or
earlier
(PRG:103)
Inverter with
SPEC: C or
earlier
(PRG:101)
Inverter with
SPEC: E or
earlier
(PRG:103)
READ (Inverter
→ Operator)
Available
Available Available Available
READ (Inverter
→ Operator)
Available
Available
*
N/A Available
VERIFY
Available N/A N/A Available

YASKAWA Varispeed f7 Specifications

General

Brand	YASKAWA
Model	Varispeed f7
Category	Inverter
Language	English