Display of revolutions of PTO shafts
Replaceable end points of rear PTO shaft
(1) - In case that the tractor is equipped with the front PTO
shaft, the revolutions of the front PTO shaft are shown on
the display of the instrument panel after switching the front
PTO shaft with the button on the right column of the cabin
and rotation of the front PTO shaft.
(2) - If independent revolutions of the rear PTO are
shifted, the revolutions of the rear PTO shaft are shown on
the display of the instrument panel after switching the rear
PTO shaft with the button on the right column of the cabin
and rotation of the rear PTO shaft.
If dependent revolutions of the rear PTO shaft
are shifted, the revolutions are not shown on the
display of the instrument panel.
P18N015
The tractor is equipped with six or twenty-one splined
replaceable end point of rear PTO shaft.
Replacement procedure:
1. Use safety ring pliers to demount a safety ring (1)
2. Remove replaceable end point by pulling in the
direction of an arrow (2)
3. Mount the end point in an opposite way, pay increased
attention to the mounting of the safety ring (1)
Replacement of the terminal shall be performed
when the engine is stopped.
Rpm of the output shaft and terminal type shall be
chosen depending on the prescribed rpm of the
coupled mechanism.
Shifting 540 and 1,000 or 540E min
-1
is possible
regardless to the number of splines of the installed
terminal.
E357
PTO DRIVE OF AGRICULTURAL MACHINES
To Next Page
Loading...
Need help?
General