Check and replacement of oil in gearbox, axle drive and rear axle portals
Drainage and inspection holes
Oil level in the gear mechanisms is checked oil gauges,
whitch is located in left rear part of the gearbox case.
A - Standard oil filling
Carry out checks when the engine is stopped.
PGPPN151
1. Drain plug of the gear mechanism.
2. Oil drain plug from the outlet for the front driving axle.
3. * Brake chamber inspection screw.
4. Plug for drainage of oil from the axle drive case.
5. Drain plugs of the left and right brake chambers.
E729
1. * Inspection and oil filling screw of the axle shaft case
(applicable for standard adjustment of the portal).
2. Plug for draining of oil from the axle shaft case.
3. * Inspection screw of the brake chamber.
*After screwing out the inspection screw the
level of oil shall reach lower edge of the inspection
hole.
E730
To Next Page
Loading...
Need help?
General