*Air filter with active carbo
PGPPN003
Active carbon filters are installed in the placed of standard dust filter and the replacement is done in the
same way as with standard filters. Filter must be inserted with the white side to the grid. Assembly
instructions are found in the chapter 'Maintenance instructions'.
Filter is used only when spraying pesticides, then it must be replaced back by a paper filter because the
flying dust would clog the carbon filter very fast.
The recirculation control must be in the position 'air is sucked from the outside'.
Ventilator control must be in the position 'maximum ventilator run'.
WARNING: filter does not provide full protection against toxic substances
- Wear protective gloves when manipulating with the filter.
- Do not clean the filter and do not blow through with compressed air.
DANGER: Replace the active carbon filter every 200 hours or 36 months (date of production is
given on the filter). If you happen to smell pesticides in the cabin, replace the filter immediately and
have the sealing of the cabin checked. Used filters must be damaged in specialized collection
centres.
When spraying pesticides and using heating filters with active carbon, the recirculation
control must be in the position of 'air sucked from the outside' and the ventilator control 'maximum
ventilator run' for creating surplus pressure in the cabin.
When spraying pesticides, increased care should be taken when entering or exiting the tractor
because of possible contamination of the working area. Follow the safety instructions for handling
esticides accordin
to the valid legislation of the country where the tractor is used, type of the
hazardous substance, instructions of the manufacturer of the hazardous substance and
manufacturer of the carried or towed sprinkler.
ACQUAINTANCE WITH TRACTOR
To Next Page
Loading...
Need help?
General