PTO selection control leve
P18N016
a - independent revolutions of the PTO shaft drive - revolutions are dependent on the engine revolutions
n - neutral position
b - dependent revolutions of the PTO shaft drive through the gearbox - revolutions are dependent on the
shifted gear
Shifting is performed when the tractor is idling.
The neutral position of the gear shift lever of dependent and independent revolutions is indicated with the
symbol N (1) on the display of the instrument panel.
When the tractor is operated and the rear PTO shaft is not used, the gear shift lever of
dependent and independent revolutions must always be in the neutral position (n).
Lever of hand brake and hitch for single-axle trailer
Shifting can be carried out when the tractor is in standstill
by pulling up or pushing down the lever.
Shifting of 540 and 1,000 (or 540E) min
-1
is
ossible re
ardless to the number of
rooves on the
installed termination. Speed of the output shaft and
type of the termination shall be chosen depending on
the prescribed speed of the aggregated machine.
a -
1,000 mi
-1
or 540E mi
-1
b -
540 mi
-1
PGPPN162
1. Hand brake lever.
2. Lever of the single-axle trailer hitch control.
When stopping or leaving the tractor you must
always secure the tractor with the parking brake.
If the tractor is standing on a slope, its wheel must be
additionally secured with wedges!
PGPPN163
ACQUAINTANCE WITH TRACTOR
To Next Page
Loading...
Need help?
General