Zeroing (reset) of the indicator of service inspection intervals
P18N073
When the maintenance was performed, zero (reset) the indicator of service inspection
intervals.
Enter the service menu by longer pressing of the button (B).
Use the buttons (C) and (D) to select the calibration item indicated with the arrow (1). Press the button (B) to
enter the calibration menu.
Use the buttons (C) and (D) to select the service item indicated with the arrow (2). Press the button (B) to
enter the service menu.
Use the buttons (C) and (D) to select the item [clearing] indicated with the arrow (3). Press the button (A) to
reset the indicator of the service interval.
Repeatedly press the button (A) to return to the main screen.
Error signalling
Errors arising during tractor operation are indicated by
switching the corresponding signal lamp, acoustic signal
and error message in the instrument panel display.
If the error is indicated, the signal lamp still glows, even
though the display is switched to the next display.
If the error is not eliminated or the indicated state has not
returned to a normal state:
the corresponding signal lamp glows
when the tractor is switched off, the key in the switch box
is moved to position I and then the engine is started, the
corresponding signal lamp is switched on again and the
error message runs through the display.
1 - The signal lamp of a serious defect of the system (red).
2 - The signal lamp of a less serious defect of the system
(orange).
3 - Operational protection signal lamp (blue).
P18N048
To Next Page
Loading...
Need help?
General